Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

一株耐盐柴油降解菌的分离鉴定及其降解性能

从某油田附近受石油污染土壤中分离出一株以柴油为惟一碳源的耐盐菌株LS1。通过对菌株的生理生化特性、菌体的形态观察及16S r DNA基因序列分析鉴定菌株LS1为假单胞菌属(pseudomonas)。该菌株可耐受的最高盐度(Na Cl)和柴油浓度分别为6%~8%和12 000 mg/L。菌株生长的适宜p H和温度条件分别为6.0~8.0和28~36℃。在盐度为6%、p H为7.0、温度为32℃、菌种投加量为10%的条件下,初始浓度为3 000 mg/L的柴油经6 d降解后,去除率可达78.3%,加入适量外加碳源葡萄糖和蔗糖,可使降解率分别提高至92%和90%左右。菌株LS1的耐盐机理可能是通过在细胞内积累甜菜碱以调节菌株细胞内外渗透压平衡。投加甜菜碱可提高耐盐菌LS1在高盐环境下对柴油的降解效率。     

低温柴油吸收工艺在高温油品储罐罐顶废气净化中的应用

采用罐区减排措施和低温馏分油吸收-脱硫工艺处理高温油品罐罐顶废气,在处理气量43.0~384.5 m3/h,柴油流量10~20 m3/h,吸收柴油温度10~15℃条件下,废气经过净化后,硫化氢和有机硫化物去除率大于97.2%,净化气体非甲烷总烃浓度小于8.35 g/m3,均低于GB20950-2007《储油库大气污染物排放标准》和GB 16297-1996《大气污染物综合排放标准》中相关污染物的限值。     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

NaOH溶液吸收CO2的试验研究

为了满足国际海事组织对船舶CO2排放的要求,建立了一种针对船舶尾气CO2的循环吸收系统,利用NaOH溶液吸收CO2.NaOH溶液完成第一步吸收反应后在第二步反应中被还原,从而可以循环利用.分析了初始反应温度、NaOH浓度及溶液中的Na2CO3对CO2吸收率的影响,并计算了循环反应中NaOH的再生率和CaO的过量系数.结果表明,CaO过量系数为1.2时对CO2固化效果最佳,此时NaOH溶液再生率达79.31％.研究表明,NaOH溶液吸收船舶尾气中CO2的循环系统效率高、成本低.     

Modelling and Prediction of Diesel Engine Performance using Relevance Vector Machine

Diesel engines are being increasingly adopted by many car manufacturers today, yet no exact mathematical diesel engine model exists due to its highly nonlinear nature. In the current literature, black-box identification has been widely used for diesel engine modelling and many artificial neural network (ANN) based models have been developed. However, ANN has many drawbacks such as multiple local minima, user burden on selection of optimal network structure, large training data size, and over-fitting risk. To overcome these drawbacks, this article proposes to apply an emerging machine learning technique, relevance vector machine (RVM), to model and predict the diesel engine performance. The property of global optimal solution of RVM allows the model to be trained using only a few experimental data sets. In this study, the inputs of the model are engine speed, load, and cooling water temperature, while the output parameters are the brake-specific fuel consumption and the amount of exhaust emissions like nitrogen oxides and carbon dioxide. Experimental results show that the model accuracy is satisfactory even the training data is scarce. Moreover, the model accuracy is compared with that using typical ANN. Evaluation results also show that RVM is superior to typical ANN approach.     

船舶柴油机选择性催化还原积碳臭氧直接氧化再生

为解决船舶柴油机SCR催化剂积碳再生问题,提出了臭氧直接氧化再生的方法。实验用玻璃纤维无胶滤筒采集PM,然后在管式炉中用臭氧氧化滤筒中的PM,研究了温度和臭氧浓度对PM氧化的影响。实验表明,臭氧的最佳氧化温度窗口为200~240℃,PM氧化速度随臭氧浓度提高明显加快,PM氧化率可以达到92%以上。根据实验结果,提出了船舶柴油机SCR积碳O3低温再生技术方案。     

Ergonomic assessment of selected workstations on a merchant ship

This study describes some key ergonomic factors within the engine room, navigation bridge and other locations of a merchant ship. Ergonomic assessments were carried out on a crew of a merchant ship. The study examines the importance of factors such as noise, vibration, heat radiation (in machinery areas), psychological stress and ergonomics of the physical arrangement of the navigation bridge. It also addresses the effect of working in confined areas for a long duration and the need to process large amounts of data, decision-making and the influence of specific operating conditions in different areas of a ship. This study includes analysis of workstations, working methods and the burden of environmental factors as well as a discussion of specific marine environmental conditions such as confined working and leisure spaces, long-term family and sociocultural separation, frequent changes in climate and time zones, and temporary physical overload and long-term psychological burdens.     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.